HI folks I would like to fit a set of Bob's Knobs on my Lx200GPS. My Scope has the 6 screws on the secondary housing a design change Meade introduced mid 2005. I have been told not to attempt installation as there is considerable scope for mess-up as the screws have to pass through a coil spring Any Advice or experince with installing on a Meade with a six-screw secondary?
I fitted them to my LX200R which is the same and had no problems.
Be sure to follow the instructions carefully though. They should specifically mention the 6 screw design. You have to tighten everything up and do one knob at a time.
Steddyman
-------------------- Skywatcher 100ED2
Skywatcher HEQ5 Pro
Nikon D200
Sony HDR-HC1E
Philips Toucam Pro II