Click here if you are having trouble logging into the forums
Privacy Policy |
Please read our Terms
of Service | Signup and
Troubleshooting FAQ | Problems? PM a Red or a Green Gu.... uh, User
starquester
professor emeritus
Reged: 09/03/04
Posts: 594
Loc: Three Rivers, MI U.S.A>
|
|
Hi All,
I am looking for a 1 5/8" shaft for my Byers 6" drive.
It is a Full Dia gear and motor, I have had it since the 1980's.
I did have a shaft and bearings for it but during a move cross cuntry (NM to MI) the shaft and Bearings were lost.
I haven't been able to replace them, and their are no local Machine shopes to go to.
Any Ideas on what to Do?
Alan
-------------------- Alan D. Otterson
Windy Ridge Observatory
41-58.966N
85-43.069W
http://www.flickr.com/
Alan Otterson
Founder&Owner
A Yahoo Observatory Group
Flip Top & Clamshell & Rubbermaid Observatories
http://tinyurl.com/yz9ckk
The Nikon D40 Astrophotography Group
http://tinyurl.com/5j8qw2
A Yahoo Astrophotography Group
|
Quintessence
Vendor
Reged: 06/03/07
Posts: 149
Loc: Austin, Texas
|
|
Alan,
Go to the website www.mscdirect.com and look on page 1791 of their catalog. You will find 304 stainless steel rod (terminology used for "shafting") in 1-5/8 inch diameter. Precision ground rod does not appear to be available in this diameter ... but standard rod might work for you.
-------------------- Half Hitch alt-az mount
|
starquester
professor emeritus
Reged: 09/03/04
Posts: 594
Loc: Three Rivers, MI U.S.A>
|
|
Thanks,
I'll check it our.
Alan
-------------------- Alan D. Otterson
Windy Ridge Observatory
41-58.966N
85-43.069W
http://www.flickr.com/
Alan Otterson
Founder&Owner
A Yahoo Observatory Group
Flip Top & Clamshell & Rubbermaid Observatories
http://tinyurl.com/yz9ckk
The Nikon D40 Astrophotography Group
http://tinyurl.com/5j8qw2
A Yahoo Astrophotography Group
|
|
5 registered and 11 anonymous users are browsing this forum.
Moderator: Charlie Hein, lineman_16735
Print Thread
|
Forum Permissions
You cannot start new topics
You cannot reply to topics
HTML is disabled
UBBCode is enabled
|
Thread views: 127
|
|
|
|
|
|
|