Click here if you are having trouble logging into the forums
Privacy Policy |
Please read our Terms
of Service | Signup and
Troubleshooting FAQ | Problems? PM a Red or a Green Gu… uh, User
vicop408
member
Reged: 03/12/09
|
question regarding CG5 AS-GT mount
#3018386 - 04/01/09 04:13 PM
|
Edit
|
Reply
|
Quote |
Quick Reply
|
|
|
I recently purchased a CG5 mount with go-to. My question is when I'm using the hand-controller, do I leave the RA and the DEC lock levers engaged(tightened)? I looked at the manual front-to-back and could not find the answer. Thanks.
---vic
|
mclewis1
Thread Killer
   
Reged: 02/25/06
Loc: New Brunswick, Canada
|
Re: question regarding CG5 AS-GT mount
[Re: vicop408]
#3018398 - 04/01/09 04:19 PM
|
Edit
|
Reply
|
Quote |
Quick Reply
|
|
|
Yes Vic, they need to be tight to keep the motors and encoders engaged, if you loosen them you'll mess up the electronics and the mount won't be able to go to accurately.
|
vicop408
member
Reged: 03/12/09
|
Re: question regarding CG5 AS-GT mount
[Re: mclewis1]
#3018402 - 04/01/09 04:22 PM
|
Edit
|
Reply
|
Quote |
Quick Reply
|
|
|
Got it. Thanks for the quick response!!!
|
hydrogia
sage
   
Reged: 01/09/09
|
Re: question regarding CG5 AS-GT mount
[Re: vicop408]
#3018953 - 04/01/09 08:52 PM
|
Edit
|
Reply
|
Quote |
Quick Reply
|
|
|
Don't tighten too much, though!
I used to tighten the heck out of the clutches to make sure that they wouldn't move, and after a while, the little piece of plastic that pushes into the shaft became smooshed. It just led to me having to tighten even more for the same effect.
Also be careful not to tighten the RA clutch too much or it will dig into the plastic housing of the RA motor during a slew. I made that mistake and didn't find out until my motors started to really whine about it in the middle of an east-west transition.
|
|
29 registered and 35 anonymous users are browsing this forum.
Moderator: Bowmoreman, bilgebay, iceblaze
Print Thread
|
Forum Permissions
You cannot start new topics
You cannot reply to topics
HTML is disabled
UBBCode is enabled
|
Thread views: 347
|
|
|
|
|
|
|