Ok, 36 holes tapped and chanfered on both sides...Done.
Now to align the spindle drill chuck with the center of the rotary table...
Then we can go to the outside and drill the 4 sets of 3 holes to attach the 2 mid rings together...
And finally add the 2 offset dowel pin holes so that everything stays aligned if and when the upper and lower section are seperated...which I hope is not TOO often.
Pic showing 2 pieces of 0.500 inch bearing shaft, one the drill chuck (upper) and one in the rotary table (lower)
Nice alignment
-------------------- A few I enjoy,
and a few more in the works ;<)
Previous
Index
Next
Flat
Re: 20 inch RC Robitic Build...a TEAM Effort....
Edit
Reply
Quote
