|
KimB
member
Reged: 02/28/08
Posts: 91
Loc: UK
|
Re: Dec motor with a mind of its own
06/30/08 06:49 PM
|
|
|
Hi Rick,
I'm not sure if it's the same with the lx200 as with the lx90 but I've found that if I start a goto and use the arrow keys before the autostar bleeps that the motors continue to run. I've also had loads of HBX cables fail only cured by re-crimping the plugs on myself.
Other motor weirdness (random slews) was caused by a trapped motor cables in the fork arm cover.
And finally the plug on my LNT module was loose like your HBX cable. I noticed that the RJ plugs are locked in place by the two shoulders on the release catch and that they were too long on the loose plug. All I did was trim a little bit off the shoulders with a knife and It clipped in perfectly.
Hope that helps. Kim
-------------------- 8" Meade lx90 LNT
|
|
0 registered and 3 anonymous users are browsing this forum.
Moderator: Joad
|
Forum Permissions
You cannot start new topics
You cannot reply to topics
HTML is disabled
UBBCode is enabled
|
Rating:
Thread views: 215
|
|
|
|
|
|
|