|
Arthur Dent
Galactic Hitch-Hiker
Reged: 10/23/08
Posts: 1182
Loc: South Yorkshire, UK
|
Re: ETX Problem - help required please
01/14/09 12:59 PM
|
|
|
UPDATE:
Went to my local friendly telescope shop with the ETX and handbox. Plugged in another handbox - same problem. Scope slews in altitude in both directions but not anticlockwise in azimuth (clockwise slewing is OK). So, it's not the handbox and it's not the curly cable.
Took base of ETX off expecting to find loose/broken wire but none were obvious. A loose plug, but no, that's not the problem either.
So it looks like it is an electronics fault in the base of the ETX, so back to Telescope House it goes!
Steve (at TH) guesses that it is a driver chip on one of the boards inside the base.
Art
--------------------
If I like it, the wife says that we can't afford it!
=======================================================
Meade ETX105 (a nice "Grab & Go" scope) & Celestron NexStar 6SE with Bob's Knobs.
Various EP's from 6mm to 26mm, Baader Hyperion 8-24mm Zoom, a 2x Barlow, 2" diagonal and 7Ah PowerTank.
MRF and Antares 8x50 RACI finder scope - both for the 6SE's OTA, whilst the ETX gets a plain RDF.
Canon EOS 400D DSLR (un-modded) and SPC900 webcam. Finally climbing the AP Learning Curve!
|
|
0 registered and 4 anonymous users are browsing this forum.
Moderator: Shadowalker, oldsalt
|
Forum Permissions
You cannot start new topics
You cannot reply to topics
HTML is disabled
UBBCode is enabled
|
Rating:
Thread views: 2135
|
|
|
|
|
|
|
Previous
Index
Next
Flat
Edit
Reply
Quote
