|
Joe Lalumia
Post Laureate
Reged: 01/24/07
Posts: 3606
Loc: Rockwall, Texas, USA
|
Re: 497 Autostar controller question. Thanks
06/06/09 07:39 PM
|
|
|
That is an ANTIQUE firmware! Version 43Eg is the latest version-- update the firmware--- and retrain-- etc etc-- enter TIME, DATE, SITE, Daylight Savings =YES and so forth...
Bottom of this page--
http://www.meade.com/support/auto.html
You will also need the ASU client software on the same page-- and the proper serial port cable from your computer to the plug on the bottom of the hand controller-- make sure the scope is turned off when you plug in the cable or remove the cable.
If you don't have the cable it can be purchased here-
http://www.scopestuff.com/ss_sma2.htm
If you only have USB ports you will ALSO need this-
http://www.scopestuff.com/ss_usbr.htm
I know lots of STUFF! But once you do all of this you will convert the ETX to full GOTO--
--------------------
LX90 8" LNT, SV Nighthawk & TelePOD, SV 80/9D & M4 mount, ETX 90, Orion XT10i, 20x80 binoculars, SV-BV3s-- www.texasastro.org
"Great minds discuss ideas;Average minds discuss events;Small minds discuss people." Unknown
Edited by Joe Lalumia (06/06/09 07:48 PM)
|
|
3 registered and 5 anonymous users are browsing this forum.
Moderator: Shadowalker, oldsalt
|
Forum Permissions
You cannot start new topics
You cannot reply to topics
HTML is disabled
UBBCode is enabled
|
Rating:
Thread views: 503
|
|
|
|
|
|
|
Previous
Index
Next
Flat
Edit
Reply
Quote
