Jump to content


* * * * *

Zhumell 12" Dobsonian Altitude Bearing Modification

Discuss this article in our forums

Zhumell 12" Dobsonian Altitude Bearing Modification

By Andrew J. De Luca

I found the altitude & azimuth bearings to be very loose on my Zhumell even when the knobs are turned down tight.

Upon removing the knob I found a roller bearing between two washer. Behind that is a plastic clutch that tightens around the shaft when pressure is applied by tightening the knob.

Figure 1

Figure 2

I tried to find the washer at Home Depot and my local hardware store without luck. I opted to fabricate one out of a piece of 1" PVC pipe. I cut 1/4 inch pieces and than used coarse sandpaper to get them under 1/8" and finished them with emery cloth.

Figure 3

Figure 4

Figure 5

Figure 6

Figure 7

When rebuilding I left the outer washer off. The fabricated washer is held in place by the shaft and the knob housing.

Figure 8

The tube still moves like butter but now the bearing clutch grabs and holds. The tube stays erect when applying pressure or moving the scope out of the garage. Total cost of project about $20.00 including tools completed in under 3 hours including planning & shopping.

Upcoming projects:

  • Wheels
  • Azimuth Clutch

  • txmnjim and mdsohio like this


Cloudy Nights LLC
Cloudy Nights Sponsor: Astronomics