I've never used the framing assistant in NINA.
I'd like to change the center of a target for a sequence. I want to get a photo of the Pillars of Creation. So, I put M16 into the Framing Assistant, and then altered the center. I see the coordinates change.
I add this to the new sequencer.
In my sequencer in the "Loop Conditions" section (right below the "Triggers" section) I have two conditions that I always use:
- Wait for altitude>=30 degrees
- Solve and Sync
Because I have altered the normal center of M16, do I need to remove this "Solve and Sync" instruction. Or, will it Solve and Sync to the new coordinates that I have found using the Framing Assistant?