I have a bit of a problem with the relationship between the mount's saddle tightening knob and my new Zwo eaf..
As you can see on the pictures, my rig's dec balance sweet spot is the same position as the eaf and the tightening knob is just too big..
So I cut it off.. But even then, the screw was almost fully in when the eaf's bracket and screws were not in the way anymore and I could lower it to its spot. Can not cut more from the screw because already have small area to grap with a pliers..
Is there any solution by any of you who had a similar problem? Maybe I do not have to buy block of metal and a few long screws