I am thinking of adding a ZWO EAF to my setup, but it appears that it may not be adaptable to my Skywatcher ST 102. Has anyone done this successfully?
Skywatcher ST 102 and ZWO EAF
Started by
ddbufalo
, Sep 11 2024 10:55 PM
2 replies to this topic
#1
ddbufalo
-
-
topic starter
- Posts: 15
- Joined: 01 Oct 2022
Lift Off
Posted 11 September 2024 - 10:55 PM
#2
maniack
-
-
- Posts: 645
- Joined: 20 Nov 2019
- Loc: SF Bay Area
Viking 1
Posted 11 September 2024 - 11:18 PM
http://www.michiana-...ry/EAF_ST80.pdf
I'm sure it wouldn't be too difficult to 3D print some parts to make it work without so much cutting.
Note that the Synta focuser shaft takes M4 screws, which can be found at the hardware store.
#3
ddbufalo
-
-
topic starter
- Posts: 15
- Joined: 01 Oct 2022
Lift Off
Posted 11 September 2024 - 11:26 PM
Thanks. I don't have access to a 3D printer and was hoping I could make it work without too much DIY fabrication.
CNers have asked about a donation box for Cloudy Nights over the years, so here you go. Donation is not required by any means, so please enjoy your stay.
Recent Topics
-
-
ZWO Video Mode Problem
squigs - Today, 11:48 AM
DSLR, Mirrorless & General-Purpose Digital Camera DSO Imaging
-
-
-
-
-
-
Flaming Star with Tadpole (5 hours integration so far)
cloudyeverynight - Today, 08:37 AM
Beginning Deep Sky Imaging
-
Setting up a astronomy noteboot with Debian (Linux)MattGER - Today, 07:16 AM
Astronomy Software & Computers
-
